Altius Glenridding Townhomes

Interior finishing | • Dulux LIFEMASTER low VOC paint with choice of one standard colour; one coat primer & two coats finish | • Two-panel square, smooth finish interior doors | • Decorative 3” base & case trim (233 profile) | • FAIRFAX round interior door knobs (as per plan) with privacy locks on bathrooms & master bedroom(s) | • Satin nickel 12” free-slide wire shelving in clothes closets; 16” wire in pantry | • 42“ vanity mirror in main bath & ensuite(s) | • MOEN Danika chrome bathroom accessories | Cabinets & Vanities: | • Standard profile thermo-foil doors & drawers in select colours with standard hardware selections | • 3/4” quartz countertops with eased edge throughout | Flooring & Wall tile: | • Full height kitchen backsplash from builders select tile; 4” row for tub/shower surrounds | • Luxury vinyl plank flooring as per plan | • Select carpet with 8 lb foam underlay, as per plan | • Schluter-Kerdi waterproofing system with 7’ of builders select tile for ensuite tiled shower (if applicable) | • 18” builder select tile surround for drop in tubs | • Vanity 4” backsplash | Appliances: | • Appliance allowance of $3,321 to Trail Appliances to be used for selection, delivery & install. | • Projects where appliances are pre-installed or other arrangements have been made do not apply | • Standard appliance openings: | - * Fridge: 35 1/2 ” W x 72 1/2” H | - Range: 30 1/4“ W | - Dishwasher: 24 1/4” W | - OTR: 29 7/8“ W x 15 5/8” H x 15 5/32” D | * Exclusions apply. Please check with an Area Manager before your appliance selections are made | Exterior finishing | • PVC double glazed, Low-E argon filled windows | • Insulated fiberglass exterior door with WEISER SSD series Smart Key Deadbolt | • Garage doors: | - Insulated overhead door (as per plan) | - 1/2 H.P chain drive opener with two remotes & keyless entry | • Asphalt shingles with a min. 25 year maufacturer warranty | Your foundation | • 8” thick cast in place reinforced concrete walls | • Retaining walls, if required, are at the purchasers expense | • Exterior foundation walls are treated with an asphalt emulsion (full foundations only) | • 4” min concrete with rebar grid garage floor supported on piles | • Detached garage (if applicable): | - Grade beam with piles or 4“ thick concrete pad with up to 8” thickened perimeter | • Driveway reinforced with rebar at 24” on center over compacted sand, width based on garage door | Heating & Ventilation: | • High efficiency forced air gas furnace | • Programmable thermostat | • White PVC floor registers | • Baseboard foyer heater (as per plan) | • Professional furnace & duct cleaning done prior to possession | Framing: | • 2” x 6” exterior walls as per plan | • 2” x 4”, 2” x 6”, or 2” x 8” interior walls | • 3/8” OSB sheathing or 3/8“ flame retardant on exterior walls as required | • 2” x 6” exterior garage walls | Electrical: | • 100 AMP service panel with capacity for 60 circuits; location at discretion of builder | • RG6 & CAT5E combo outlets as per plan, USB-port electrical outlet in kitchen | • GFI protection for exterior weather-proof outlets | • Combination smoke/carbon monoxide detectors and smoke detectors in bedrooms | • Pre-selected satin nickel light fixture package and LED disc lights (as per plan) | Plumbing: | • Double compartment stainless steel drop-in sink with MOEN Integra faucet with pull-down spray | • Water line rough-in to fridge/dishwasher locations | • Oval drop-in sink with MOEN Danika single lever faucet & tub/shower trim in main bath & ensuite(s) | • Pedestal or wall-mount sink with MOEN Danika single lever faucet in powder room | • Mansfield Alto toilets throughout | • Minimum 40 Gallon electric or gas hot water tank | • Sump with discharge as required | • Radon mitigation system rough in | • 3-piece rough in in basement as per plan | Insulation & Drywall: | • R20 batt insulation with 1/2” drywall on exterior walls | • 2 lb spray foam insulation in cantilevers | • Stipple ceiling texture | • R40 blown in insulation in attic area | • Two layers of R12 insulation with air space between floors in stacked townhomes | • Party walls: | - R12 batt insulation on both sides of party wall; single layer of 5/8“ fire-rated drywall on each side | - Additional layer of 1/2” drywall on one side | - Offset 2“ x 4” walls with 1” air gap | • Attached garage: | - Exterior walls - R20 batt insulation, drywalled including fire taping | - Ceiling - R28, 1/2 pound spray foam (townhomes only) | - 5/8” fire-rated drywall on each side of the party wall | • Detached garage: | - 5/8” fire-rated drywall on each side of the party wall